![]() Is there some another magic (free) tool which could do this job? EasyUS seems not to be free any more and I am not sure it could do this job either if I would pay for it. Clover EFI Bootloader can boot OS X, Windows, and Linux on Mac or PC with UEFI or BIOS firmware. My conclusion is that the partitionwizard tool managed to 'move' the 2nd partition to make there an extra space for the EFI partition but somehow it went wrong or maybe such migration is not possible in theory at all. ![]() tried to boot Windows 10 installation, and from Shilft + F10 console the mbr2gpt command, again, same error.Output file: where the VHD file will be saved. mbr2gpt /validate / disk:0 /allowsFullOS -> shows error Cannot find OS partition(s) for Disk 0 In the Input file box, browse to the /sources/install.wim file.mbr2gpt /convert /disk:0 /allowsFullOS -> shows error Cannot find OS partition(s) for Disk 0.used a partitionwizard tool to make between the recovery and the system partition extra 110MB space.mbr2gpt /convert /disk:0 /allowsFullOS -> shows error Cannot find room for the EFI system partition.mbr2gpt /validate /disk:0 /allowsFullOS -> shows everything is ok with the disk.boot does not work (I assume because it is not UEFI).made the HDD to a primary disk in the computer (physically swapped the disks).used HDD copy Raw tool to clone the content of the VHDX to a free HDD (both partitions - recovery 600MB and the standard system partitions, partition is active, should be bootable) The issue is that clover does not see the drive, I have the NVME driver properly installed in the efi partition. ![]() mounted VHDX in running windows 10 as virtual disk. ![]() Now I want to make the content of this VHDX file to my primary content on the Disk and boot from it direcly on a computer which is UEFI only. I have a VHDX file with bootable Windows 10 system which was used as a 2nd dual-boot system on another Windows 10 instance (natively VHDX booted). ![]()
0 Comments
Leave a Reply. |